Custom Head Spacers (turbo guys)

[VRspeed]

Hey guys/gals,

New here to the forum.

I have designed a head gasket spacer to reduce the compression for turbo setups etc. It replaces the center section in a factory 3-layer steel head gasket. It was drawn using a CMM (coordinate measuring machine) so the end result was extremely accurate. My current design is drawn from a 1st gen DOHC gasket.

I usually have them cut from .080" stainless, but any thickness is available. The .080" spacer lowered the compression by approx. 1 point.

Here is a link to i picture of it on my website.

http://www.vrspeed.com/flangesadapters.html

Open to any comments, questions and suggestions.

Thanks

[Casketbearer]

Cool stuff, I might have some projects for you in the coming months...