Custom Head Spacers (turbo guys)
Posted: Wed Jun 08, 2005 10:50 am
Hey guys/gals,
New here to the forum.
I have designed a head gasket spacer to reduce the compression for turbo setups etc. It replaces the center section in a factory 3-layer steel head gasket. It was drawn using a CMM (coordinate measuring machine) so the end result was extremely accurate. My current design is drawn from a 1st gen DOHC gasket.
I usually have them cut from .080" stainless, but any thickness is available. The .080" spacer lowered the compression by approx. 1 point.
Here is a link to i picture of it on my website.
http://www.vrspeed.com/flangesadapters.html
Open to any comments, questions and suggestions.
Thanks
New here to the forum.
I have designed a head gasket spacer to reduce the compression for turbo setups etc. It replaces the center section in a factory 3-layer steel head gasket. It was drawn using a CMM (coordinate measuring machine) so the end result was extremely accurate. My current design is drawn from a 1st gen DOHC gasket.
I usually have them cut from .080" stainless, but any thickness is available. The .080" spacer lowered the compression by approx. 1 point.
Here is a link to i picture of it on my website.
http://www.vrspeed.com/flangesadapters.html
Open to any comments, questions and suggestions.
Thanks